SB has a setting for the FC and from the literature I found from GraphTec it does not need a special driver and it should work with generic HP drivers. SignTools 4 cuts from the bottom left of the page either manually place object s in the bottom left of the CorelDRAW page or use the "Vinyl Saver" tool with the sliding bar all the way to the left. Next click on the "Cut" button and then the "Cut Settings" Button. Select the Graphtec FC from the "Cutter" drop down box and select your port. You don't even state what cutter you have.. We recommend the following brands which are fully supported: Should I install somenthing special for Windows 7 x64?
| Uploader: | Felkree |
| Date Added: | 28 June 2008 |
| File Size: | 45.72 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 68056 |
| Price: | Free* [*Free Regsitration Required] |
Any idea what else must be changed? Hello Lucian, sorry for our very late answer. I am using a 25 pin Male to Male cable. fc1300-60
I am so confused. It's a Graphtec ce Posted December 12, I was trying to use SignBlazer fc3100-60 my new Graphtec but am not having any luck. Which model is supported?
Posted December 15, The machine can only automatically be detected if it uses a genuine USB connection without additional drivers.
I guess I need to figure out how to tell the cutter that I am using the Parallel cable. Hi, thanks for your inquiry.
List of vinyl cutters supported by DrawCut PRO and EXPERT
Or what Cutter you are running under in Signblazer. You can download it on the Graphtec site. You still don't state what graphtwc In computer device manager and Signblazer.
Cutting Plotters : Software & Drivers
A dialog box will appear. You must set your plotter to HP-GL emulation through the plotter's control panel.
Don't know about your cables. Secabo, Roland Summa, Mimaki, Graphtec.
signtools4.com
I matched my com port settings and now SB is communicating with my Graphtec. You are right the RS-1 is for Serial, thanks. You don't state what you have done already. I stopped by a computer repair store and picked up a cable.
List Of Supported Cutters - SignGo
Is there a quick answer to adjusting that? Please follow these instructions to install the required driver: Maybe you would like to give DrawCut a try. SignTools will not communicate with your Gerber plotter with a different cable. If you wish to cut in a portrait fashion simply rotate your graphics.
The Mimaki CGFX can only use the manual cropmark drriver system but neither the automatic, nor the barcode reading feature.
Here are the things I did but I don't think they did anything I am almost sure it was the cable. Where would I go dfiver finding the software??
So maybe it is time to start over with a new machine in as well. Set Width to mm inches and Height to mm To cut any object in CorelDraw, simply place on the page in the bottom left corner.
No comments:
Post a Comment